An Earthquake Auger is the most powerful agricultural tool ever created. The tool, also called an earth tremble auger, has been around for over one hundred years and continues to be used today to dig up massive amounts of dirt and soil for farmers, ranching, mining and for other land purposes. This amazing device comes with a wire coil that is wrapped around the shaft of the auger above the ground. As the wire coils go through the earth, it creates a violent shaking motion that can literally rip up the ground and force it open.

How the auger powerhead works is like this; the first coil, also called the driving coil, is dug into the earth under the ground. Then the second coil, or the driving blade, is inserted into the first coil. Earthquake Auger Once both blades are inserted, the wire coils react to the grinding motion and produce a massive amount of rocking effect. This motion drives the "punch" through the earth and creates the rocking effect that is commonly associated with this revolutionary equipment.


This type of rock digger can dig through soil that is over half a mile underground. You can get this device in models that can handle up to thirty-seven pounds of earth and there are models that can handle up to fifty-seven pounds of soil. The average cost of an Earthquake Auger is about eight hundred dollars. Most of these machines are powered by gasoline, but you can buy models that run on propane as well.

Most of the time, farmers use these hydraulic excavators to help them clear fields where they have tilled land and turned a piece of land into a wheat or grain field. These are basically garden augers that are modified to handle soil that is two-thirds smaller than the original piece of land. The modified augers have two "cores" and these cores are used as a lubricating system for the machine as well as to keep the ground slip free so that the auger can operate properly.

1-man earth and rock eater are also known as a mini digger and it has a single cutter that spins like a drill. It is equipped with a handle and this is the part that a person uses to do the actual digging. This type of hydraulic excavator has a trigger that allows the operator to limit how far the unit will go underground. The last type of earth and rock eater is called a full-size earthquake auger and it is equipped with a handle and a hoist. This type of auger is useful when it comes to extracting soil or sand from underground.

When these two people are going to work, it is important for them to be sure that everyone is safe. This is because one of these devices is able to cut through the earth and rocks so that only certain parts of the area will be accessed. If a garden is constructed around one of these augers, then it would be easier for workers to extract the soil or sand from the garden. If a garden is located outside, then there is a greater chance of the garden being damaged if the earth auger is operating at a depth of below five feet.

After the digging is done, the two people who will be using the auger need to use the handlebars in order to be able to control it. These handlebars are fitted with triggers and they have to be pressed into the ground to be able to move the auger forwards or backwards. It is important for the workers to be aware of how far ahead or behind they are when they are digging so that they do not injure themselves from falling backwards because of too much movement of the soil.

When all the dirt has been removed, it is time to erect the auger. All the pieces of the auger need to be assembled so that they are all lined up. The final step involves the installation of the choke and the throttle. The choke should be placed on the end of the auger just behind the run position. It is advisable to install the choke on the end of the line which runs through the center of the auger so that this choke does not slip or get tangled with the other pieces of the auger while the auger is still in operation.